Chat NowStraight Grinder (For Mounted Point Rotary Bar With Shaft)
Caution
- The product images are representative only. Specifications may differ for each part number, including shape and color.
Product Description
[Features]
·For a mounted point rotary bar.
[Applications]
·For mold finishing, deburring, chamfering, pipe inner finishing, etc.
Product features and specifications
Basic specifications and features of the product
- UG-25NA/UG-38N/UG-38NA/UG-38NL/UG-50S-200: Lever type. Grinding wheel is not included.
- UG-25NSA/UG-38NS/UG-38NSA/UG-38NSL: Roll type. Grinding wheel is not included.
Collet chuck
UG-25N series
UG-38N series, chuck CP (Chuck + chuck nut)
Standard table
* Air pressure 0.6 MPa (Gauge) data when no load is applied.
* When installing the carbide rotary bar, be sure to use an overhang of 13 mm or less.
* Do not use mounted points whose diameter is ø50 and larger.
* Rear exhaust type
* Air pressure 0.6 MPa (Gauge) data when no load is applied.
* When installing the carbide rotary bar, be sure to use an overhang of 13 mm or less.
* Do not use mounted points whose diameter is ø50 and larger.
Cautions/prohibitions
To use the air grinder safely
The following are the minimum required precautions. For details, please use in accordance with the provisions of the Occupational Safety and Health Structural Standards.
The Industrial Safety and Health Act of Japan (Act No. 57 of 1972)
The Ordinance on Industrial Safety and Health (Ministry of Labor Ordinance No. 32, 1972)
Structural rules for grinding machines, etc. (March 8, 1971, Ministry of Labor Notification No. 8, Partly September 30, 1965, Ministry of Labor Notification No. 85)
1. Check the specification display on the air grinder main body and grinding wheel cover. Maximum rotational speed without load, diameter / thickness / hole diameter of grinding wheels that can be used, rotation direction of grinding wheels, maximum peripheral speed of grinding wheels.
2. For grinders with a speed governing device (governor), periodically check the rotational speed to see if it is operating properly to maintain the normal rotational speed, and if there is an abnormality, immediately prohibit the use.
3. Be sure to use the specified flanges and covers for the grinding wheels, check whether the mounting conditions are normal, and prohibit use immediately if there are any abnormalities such as non-specified dimensions, quality defects, wear, or parts shortage.
4. Use grinding wheels of quality and strength that meet the regulations, and prohibit the use of grinding wheels that have abnormalities such as damage or deterioration.
5. Install, replace and test the grinding wheels in a specific safe place with a specific responsible person.
Be sure to perform a test run for 1 minute before the start of grinding work and 3 minutes after replacing the grinding wheels in a specific safe place to check for any abnormalities.
6. Take great care not to exceed the specified rotational speed of the grinder, and do not increase the air pressure used above the specified value to increase the rotational speed.
7. Be sure to properly attach the appropriate grinding wheel cover to the air grinder that uses a grinding wheel with a diameter of 50 mm or more.
8. Never use at a rotational speed higher than the maximum operating speed indicated on the grinding wheel.
9. Do not use the sides of the grinding wheels other than the intended purpose of the grinding wheels.