6060, Slot Width 10mm Aluminum Frames (Part Numbers)

Slot width 10mm Square 6060 Profile.

Material	Surface Treatment
6063-T5	Clear Anodize

■Specified Length

Type	Profile	Overall Length L	Profile Type	Mass kg/m	Collective moment of inertia		Sectional moment of inertia
					lx（cm4）	ly（cm4）	Zx（cm4）	Zy（cm 4）
LCF10	6060	50～6000	Standard	3.82	45.02	45.02	15	15
LCFL10			Light	2.43	29.2	29.2	9.73	9.73

When scheduled under a fixed model, the effective length is 4000mm. The product length may exceed 4000mm, and there may be slight oxidation marks on both ends!

Alteration	Alteration Symbol	Specification	Machining/Corresponding Accessories
End Tapping (Center Hole)	LTP/RTP/TPW		Tapping holes on the end face of aluminum profiles Parts used for this additional processing: Button Head Screws
45-Degree Cutting	L□T45/R□T45		Cutting with 45-degree angle.
Drilling Wrench Hole	LWP/RWP		Drilling Wrench holes in fixed positions for Blind joint connections. Parts used for this additional processing: Button Head Screws
Counterboring	Z8/XA		Machining Counterbored holes at any specified positions. Parts used for this additional processing: Button Head Screws
S Hole Blind Joint Dedicated	LSH/RSH		Adding S holes for Pre-Assembly Insertion Double Joint connections. Parts used for this additional processing: Blind Joints, Pre-Assembly Insertion Double Joint Kits
M Hole Blind Joint Dedicated	LMH/RMH		Adding M holes for Post- Assembly Insertion Double Joints, Center Joint connections. Parts used for this additional processing： Blind Joints, Pre-Assembly Insertion Center Joint Kits

1.Implement the GB industrial aluminum profile standard, 8~10μ anodized treatment, the surface is scratch-resistant.
2.A protective film is attached to the surface of the profile to prevent friction and damage during transportation.
3.Any length can be specified within the range of 50mm~2000(2500) for  cutting.
4.Compatible with various alterations such as drilling and chamfering.
5.Economy Series profiles are different from MISUMI’s existing profile cross-sectional shape, and the specifications are compared as follows:1.The surface of the profile is covered with a protective film, and there may be a small amount of aluminum chips remaining, which is not a quality problem. 
After the film is removed, the aluminum chips will be removed.
2.Economy series products are different from MISUMI existing profiles in section shapes, so they can only be used with Economy series special accessories starting with L.

Recommended product 1	Recommended product 2	Recommended products 3
Economical European standard 40 series aluminum profile groove width 10mm	Economical single-sided protruding corner code dedicated to European standard aluminum profiles	Economical PVC board PVC board standard type